Configuring an IES Service with CLI
Page 690 7750 SR OS Services Guide
Common Configuration Tasks
This section provides a brief overview of the tasks that must be performed to configure IES
services and provides the CLI commands.
1. Associate an IES service with a customer ID.
2. Associate customer ID with the service.
3. Assign an IP address.
4. Create a subscriber interface (optional).
5. Create an interface.
6. Define SAP parameters on the interface
→ Select node(s) and port(s).
→ Optional - select QoS policies other than the default (configured in the
config>qos
context).
→ Optional - select filter policies (configured in the
config>filter context).
→ Optional - select accounting policy (configured in the
config>log context).
7. Enable service.
To Next Page
Loading...
