Virtual Leased Line Services
7750 SR OS Services Guide Page 147
Configuring a VLL Service with CLI
VPRN This section provides information to configure Virtual Leased Line (VLL) services using the
command line interface.
Topics in this section include:
• List of Commands on page 149
• Basic Configurations on page 160
• Common Configuration Tasks on page 166
→ Configuring VLL Components on page 166
− Creating an Epipe Service on page 167
− Creating an Apipe Service on page 176
− Creating an Fpipe Service on page 182
− Creating an Ipipe Service on page 187
− Using Spoke SDP Control Words on page 191
→ Configuring Pseudowire Scenarios
− Pseudowire Configuration Notes on page 193
− Configuring Two VLL Paths Terminating on T-PE2 on page 195
− Configuring VLL Resilience on page 199
− Configuring VLL Resilience for a Switched Pseudowire Path on page 201
• Service Management Tasks on page 204
Epipe:
→ Modifying Epipe Service Parameters on page 205
→ Deleting an Epipe Service on page 206
→ Re-enabling an Epipe Service on page 206
→ Re-enabling an Epipe Service on page 206
Apipe:
→ Modifying Apipe Service Parameters on page 207
→ Disabling an Apipe Service on page 209
→ Re-enabling an Apipe Service on page 210
→ Deleting an Apipe Service on page 211
Fpipe:
→ Modifying Fpipe Service Parameters on page 212
→ Disabling an Fpipe Service on page 214
→ Re-enabling an Fpipe Service on page 215
→ Deleting an Fpipe Service on page 216
To Next Page
