Configuring an IES Service with CLI
Page 682 7750 SR OS Services Guide
List of Commands
Table 23 lists all the service configuration commands indicating the configuration level at which
each command is implemented with a short command description. The command list is organized
in the following task-oriented manner:
• Create an IP address range reserved for IES
• Configure IES service parameters
→ Configure IES subscriber interface parameters on page 682
→ Configure IES subscriber interface group interface parameters on page 683
→ Configure interface parameters
− Configure IES interface ICMP parameters
− Configure IES interface IPv6 parameters
− Configure IES interface spoke-SDP parameters
− Configure VRRP parameters
• Configure SAP parameters
→ Configure SAP ATM parameters
s
Table 1: CLI Commands to Configure IES Service Parameters
Command Description Page
Create an IP address range reserved for IES
config>router
service-prefix
Creates an IP address range reserved for IES to provide a mechanism to
reserve one or more address ranges for services.
Configure IES service parameters 691
config>service
ies
Creates an IES service instance and specifies the customer ID number to
be associated with the service.
719
customer
Specifies the customer ID number to be associated with the service. 720
no shutdown
Administratively enables the service. 717
Configure IES subscriber interface parameters
config>service>ies>sub-if
address
Assigns an IP address, IP subnet, and broadcast address format to an IES
IP router interface.
729
dhcp
Configures DHCP parameters for the subscriber interface. 742
group-interface
Enables the context to configure a group interface.
To Next Page
Loading...
