Internet Enhanced Services
7750 SR OS Services Guide Page 683
Configure IES subscriber interface group interface parameters
config>service>ies>sub-if>grp-if
arp-populate
Disables dynamic learning of ARP entries. 739
arp-timeout
Configures the minimum time in seconds an ARP entry learned on the IP
interface will be stored in the ARP table.
733
authentication-
policy
Assigns a RADIUS authentication policy to the interface. 722
description
Creates a text description stored in the configuration file for a configura-
tion context.
718
dhcp
Configures DHCP parameters for this interface 742
host-connectivity-
verify
Enables host connectivity verification for all hosts on this interface. 769
local-proxy-arp
Enables local proxy ARP on the interface. 734
mac
Assigns a specific MAC address to an IES IP interface. 735
proxy-arp-policy
Configures a proxy ARP policy for the interface. 738
remote-proxy-arp
Enables remote proxy ARP on the interface. 739
tos-marking-state
Changes the default trusted state to a non-trusted state. 737
Configure IES group interface SRRP parameters
config>service>ies>sub-if>grp-if>srrp
gw-mac Overrides the default SRRP gateway MAC address used by the SRRP instance.
723
keep-alive-interval
defines the interval between SRRP advertisement messages sent when
operating in the master state.
724
message-path
defines a specific SAP for SRRP in-band messaging. 724
policy
associates one or more VRRP policies with the SRRP instance. 726
priority
overrides the default base priority for the SRRP instance. 726
no shutdown
Administratively enables the entity. 717
Configure interface parameters 693
config>service>ies>interface interface-name
active-cpm-
protocols
Enables or disables CPM protocols on this interface. 729
address
Assigns an IP address, IP subnet and broadcast address format to an IES or
IES IP router interface.
729
allow-directed-
broadcasts
Enables the forwarding of directed broadcasts out of the IP interface. 731
arp-populate
Enables populating static and dynamic hosts into the system ARP cache. 739
Table 1: CLI Commands to Configure IES Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
