Virtual Private LAN Services
7750 SR OS Services Guide Page 559
Show Commands
egress-label
Syntax egress-label egress-label1 [egress-label2]
Context show>service
Description Display services using the range of egress labels.
If only the mandatory egress-label1 parameter is specified, only services using the specified label are
displayed.
If both egress-label1 and egress-label2 parameters are specified, the services using the range of labels
X where egress-label1 <= X <= egress-label2 are displayed.
Use the show router ldp bindings command to display dynamic labels.
Parameters egress-label1 — The starting egress label value for which to display services using the label range. If
only egress-label1 is specified, services only using egress-label1 are displayed.
Values 0, 2049 — 131071
egress-label2 — The ending egress label value for which to display services using the label range.
Default The egress-label1 value.
Values 2049 — 131071
Output Show Service Egress Command Output — The following table describes show service
egress label output fields.
Table 6: Show Service Egress Label Output Fields
Label Description
Svc Id
The ID that identifies a service.
Sdp Id
The ID that identifies an SDP.
Type
Indicates whether the SDP binding is a spoke or a mesh.
I. Lbl
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
E. Lbl
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
Number of bind-
ings found
The total number of SDP bindings that exist within the specified egress
label range.
To Next Page
Loading...
