Internet Enhanced Services
7750 SR OS Services Guide Page 695
Configuring SAP Parameters
IES SAP
A SAP is a combination of a port and encapsulation parameters which identifies the service access
point on the interface and within the router. Each SAP must be unique within a router.
When configuring IES SAP parameters, a default QoS policy is applied to each ingress and egress
SAP. Additional QoS policies and scheduler policies must be configured in the
config>qos
context. Filter policies are configured in the
config>filter context and must be explicitly
applied to a SAP. There are no default filter policies.
IES interface ATM SAP parameters can only be configured on ATM-type MDAs and ATM-
configured ports. See the 7750 SR OS Basic System Configuration Guide.
Refer to IES Services Command Reference on page 705 for CLI syntax.
The following displays the command usage to configure IES interface parameters:
Example: config>service# ies 1000
config>service>ies# interface test
config>service>ies>if# sap 5/1/3.1:0 create
config>service>ies>if>sap# ingress
config>service>ies>if>sap>ingress# qos 101
config>service>ies>if>sap>ingress# exit
config>service>ies>if>sap# egress
config>service>ies>if>sap>egress# scheduler-policy alpha
config>service>ies>if>sap>egress# qos 1010
config>service>ies>if>sap>egress# exit
config>service>ies>if>sap# exit
config>service>ies>if#
This example displays an IES SAP configuration.
*A:ALA-A>config>service>ies>if# info
----------------------------------------------
address 10.10.36.2/24
sap 5/1/3.1:0 create
ingress
qos 101
exit
egress
scheduler-policy "alpha"
qos 1010
exit
exit
----------------------------------------------
*A:ALA-A>config>service>ies>if#
To Next Page
Loading...
