OAM and SAA Command Reference
7750 SR OS Services Guide Page 1453
OAM SAA Commands
saa
Syntax saa test-name [owner test-owner] {start | stop}
Context oam
Description Use this command to start or stop an SAA test.
test-name — Name of the SAA test. The test name must already be configured in the config>saa>test
context.
owner test-owner — Specifies the owner of an SAA operation up to 32 characters in length.
Values If a test-owner value is not specified, tests created by the CLI have a default owner
“TiMOS CLI”.
start — This keyword starts the test. A test cannot be started if the same test is still running.
A test cannot be started if it is in a shut-down state. An error message and log event will be
generated to indicate a failed attempt to start an SAA testrun.
stop — This keyword stops a test in progress. A test cannot be stopped if it is not in progress. A log
message will be generated to indicate that an SAA testrun has been aborted.
To Next Page
Loading...
