Alcatel-Lucent 7750 SR OS - Cross Connecting Network IP Interfaces

Common Configuration Tasks
Page 1250 7750 SR OS Services Guide
egress
pool
resv-cbs percent-or-default
slope-policy slope-policy-name
ingress
pool
resv-cbs percent-or-default
slope-policy slope-policy-name
mac ieee-address
mtu mtu-bytes
weight path-weight
The following example displays the command usage to provision CCAG path parameters:
Example:config>vsm# ccag 1 create
config>vsm>ccag# path a
config>vsm>ccag>path# weight 100
config>vsm>ccag>path# exit
config>vsm>ccag# path b
config>vsm>ccag>path# rate 99999999
config>vsm>ccag>path# weight 100
config>vsm>ccag>path# exit
onfig>vsm>ccag# no shutdown
The following example displays the configuration:
A:ALA-48>config>vsm# info
----------------------------------------------
ccag 1 create
description "VSM test"
member-cca 10/1
path a
weight 100
exit
path b
weight 100
rate 99999999
exit
no shutdown
exit
...
----------------------------------------------
A:ALA-48>config>vsm#
Cross Connecting Network IP Interfaces
To support cross connection between services and network IP interfaces, the network interface
port command has been augmented to allow the binding of the IP interface to a ccag cc-id. Similar
to service CCAG SAPs, the network IP interface port binding command must reference the ccag-
id, the CCA path (.a or .b) and the cc-id used by the service CCAG SAP on the other CCA path.