Alcatel-Lucent 7750 SR OS - Configuring IES Subscriber Interface Parameters

Configuring an IES Service with CLI
Page 692 7750 SR OS Services Guide
Configuring IES Subscriber Interface Parameters
NOTE: Subscriber interfaces operate only with basic (or enhanced) subscriber managment. At the
very least, a host, either statically configured or dynamically learned by DHCP must be present in
order for the interface to be useful.
Refer to IES Services Command Reference on page 705 for CLI syntax to configure IES
subscriber interface parameters.
The following displays the command usage to configure IES interface parameters:
Example: config>service# ies 1000
config>service>ies$ subscriber-interface "test1" create
config>service>ies>if$ address 143.144.145.1/24
config>service>ies>if# group-interface "new-if" create
config>service>ies>sub-if>grp-if# sap 1/2/19:0 create
config>service>ies>sub-if>grp-if>sap# ingress
config>service>ies>sub-if>grp-if>sap>ingress# filter ip 10
config>service>ies>sub-if>grp-if>sap>ingress# qos 2
config>service>ies>sub-if>grp-if>sap>ingress# exit
The following example displays the subscriber interface configuration:
A:ALA-48>config>service>ies>sub-if# info
----------------------------------------------
address 143.144.145.1/24
group-interface "new-if" create
sap 1/2/19:0 create
ingress
qos 2
filter ip 10
exit
host ip 143.144.145.100 mac 00:01:00:00:00:01
exit
exit
----------------------------------------------
A:ALA-48>config>service>ies>sub-if#