Configuring a VPLS Service with CLI
Page 376 7750 SR OS Services Guide
Configuring VPLS Components
Use the CLI syntax displayed below to configure the following entities:
• Configuring Egress Multicast Groups on page 376
• Creating a VPLS Service on page 378
→ Enabling MAC Move on page 378
• Configuring a VPLS SAP on page 386
→ Local VPLS SAPs on page 386
→ Distributed VPLS SAPs on page 387
→ Configuring SAP-Specific STP Parameters on page 389
→ STP SAP Operational States on page 393
→ Configuring VPLS SAPs with Split Horizon on page 396
→ Configuring SAP Subscriber Management Parameters on page 399
• Configuring SDP Bindings on page 400
→ Mesh SDP on page 401
→ Spoke SDP on page 402
• Configuring VPLS Redundancy on page 413
• Configuring Provider Edge Discovery Policies on page 428
Configuring Egress Multicast Groups
Use the following CLI syntax to create a VPLS service:
CLI Syntax: config>service# egress-multicast-group group-name
description description-string
dest-chain-limit [destinations per pass]
sap-common-requirements
dot1q-etype 0x0600..0xffff
egress-filter [ip ip-filter-id]
egress-filter [ipv6 ipv6-filter-id]
egress-filter [mac mac-filter-id]
no egress-filter [ip ip-filter-id] [ipv6 ipv6-filter-id]
[mac mac-filter-id]
encap-type {dot1q|null}
Example
:config>service# egress-multicast-group “vpls-emg-1”
config>service>egress-multicast-group# dest-chain-limit 10
config>service>egress-multicast-group# sap-common-requirements
config>service>egress-multicast-group>sap-common-requirements#
dot1q-etype 0x060e
config>service>egress-multicast-group>sap-common-requirements#
To Next Page
Loading...
