Mirror Services
7750 SR OS Services Guide Page 1351
egress
Syntax egress
Context config>mirror>mirror-dest>sap
Description This command enables access to the context to associate an egress SAP Quality of Service (QoS) pol-
icy with a mirror destination SAP.
If no QoS policy is defined, the system default SAP egress QoS policy is used for egress processing.
qos
Syntax qos policy-id
no qos
Context config>mirror>mirror-dest>sap>egress
Description This command associates a QoS policy with an egress SAP for a mirrored service.
By default, no specific QoS policy is associated with the SAP for egress, so the default QoS policy is
used.
The no form of the command removes the QoS policy association from the SAP, and the QoS policy
reverts to the default.
Default QoS policy-id 1.
Parameters policy-id — The QoS policy ID to associate with SAP for the mirrored service. The policy ID must
already exist.
Values 1 — 65535
sdp
Syntax sdp sdp-id[:vc-id] [egr-svc-label label | tlpd]
no sdp
Context config>mirror>mirror-dest
Description This command binds an existing (mirror) service distribution path (SDP) to the mirror destination
service ID.
The operational state of the SDP dictates the operational state of the SDP binding to the mirror desti-
nation. If the SDP is shutdown or operationally down, then SDP binding is down. Once the binding is
defined and the service and SDP are operational, the far-end 7750 SR defined in the config service
sdp sdp-id far-end parameter is considered part of the service ID.
Only one SDP can be associated with a mirror destination service ID. If a second sdp command is
executed after a successful SDP binding, an error occurs and the command has no effect on the exist-
ing configuration. A no sdp command must be issued before a new SDP binding can be attempted.
To Next Page
Loading...
