VLL Service Configuration Commands
Page 252 7750 SR OS Services Guide
policy-id — The ingress/egress policy ID to associate with SAP or IP interface on ingress/egress. The
policy ID must already exist.
Values 1 — 65535
shared-queuing — This keyword can only be specified on SAP ingress. The shared-queueing
keyword specifies the shared queue policy will be used by this SAP. When the value of this
object is null, the SAP will use individual ingress QoS queues, instead of the shared ones.
queue-override
Syntax [no] queue-override
Context config>service>epipe>sap>egress
config>service>epipe>sap>ingress
config>service>apipe>sap>egress
config>service>apipe>sap>ingress
config>service>fpipe>sap>egress
config>service>fpipe>sap>ingress
config>service>ipipe>sap>egress
config>service>ipipe>sap>ingress
Description This command enables the context to configure override values for the specified SAP egress or
ingress QoS queue. These values override the corresponding ones specified in the associated SAP
egress or ingress QoS policy. If the policy was created as a template policy, this command overrides
the parameter and its description and queue parameters in the policy.
queue
Syntax [no] queue queue-id
Context config>service>epipe>sap>egress>queue-override
config>service>epipe>sap>ingress>queue-override
config>service>apipe>sap>egress>queue-override
config>service>apipe>sap>ingress>queue-override
config>service>fpipe>sap>egress>queue-override
config>service>fpipe>sap>ingress>queue-override
config>service>ipipe>sap>egress>queue-override
config>service>ipipe>sap>ingress>queue-override
Description This command specifies the ID of the queue whose parameters are to be overridden.
Parameters queue-id — The queue ID whose parameters are to be overridden.
Values 1 — 32
To Next Page
Loading...
