Alcatel-Lucent 7750 SR OS - Page 367

Virtual Private LAN Services
7750 SR OS Services Guide Page 367
oam
Specifies whether or not the GSMP ANCP OAM capability should be
negotiated at startup of the GSMP connection.
475
hold-multiplier
Configures the hold-multiplier for the GSMP connections in this group. 475
keepalive
Configures keepalive values for the GSMP connections in this group. 475
neighbor
Configures a GSMP ANCP neighbor. 475
local-address
Configures the source ip-address used in the connection towards the
neighbor.
476
priority-marking
Configures the type of priority marking to be used. 476
no shutdown
Administratively disables a GSMP entity. 457
Configure SAP ATM parameters
config>service>vpls>sap>atm#
egress
Enables the context to configure egress ATM attributes for the SAP. 501
ingress
Enables the context to configure ingress ATM attributes for the SAP. 502
traffic-desc
Assigns an ATM traffic descriptor profile to a given context. 502
encapsulation
Configures RFC2684 encapsulation for an ATM PVCC delimited SAP. 501
oam
Enables the context to configure OAM functionality for a PVCC
delimiting a SAP.
502
alarm-cells
Configures AIS/RDI fault management on a PVCC. 503
Configure SAP egress parameters
config>service>vpls>sap#
egress
Configures egress SAP QoS policies and filter policies. 504
filter
Associates an IP filter policy or MAC filter policy with an egress SAP. 505
qos
Associates a Quality of Service (QoS) policy with an egress SAP. 507
queue-override
Enables the context to configure override values for the specified SAP
egress QoS queue.
508
queue
Specifies the ID of the queue whose parameters are to be overridden. 508
adaptation-rule
Overrides specific attributes of the specified queue’s adaptation rule
parameters.
509
cbs
Overrides specific attributes of the specified queue’s CBS parameters. 511
high-prio-only
Overrides specific attributes of the specified queue’s high-prio-only
parameters.
512
mbs
Overrides specific attributes of the specified queue’s MBS parameters. 512
rate
Overrides specific attributes of the specified queue’s Peak Information
Rate (PIR) and the Committed Information Rate (CIR) parameters.
514
Table 1: CLI Commands to Configure VPLS Service Parameters (Continued)
Command Description Page