Virtual Private LAN Services
7750 SR OS Services Guide Page 507
Default no multicast-group
Parameters group-name — The group-name is required when specifying egress multicast group membership on a
SAP. An egress multicast group with the specified egress-multicast-group-name must exist and
the SAP must pass all common requirements or the command will fail.
Values Any valid egress multicast group name.
Default None, an egress multicast group name must be explicitly specified.
qinq-mark-top-only
Syntax [no] qinq-mark-top-only
Context config>service>vpls>sap>egress
Description When enabled (the encapsulation type of the access port where this SAP is defined as qinq), the qinq-
mark-top-only command specifies which P-bits to mark during packet egress. When disabled, both
set of P-bits are marked. When enabled, only the P-bits in the top Q-tag are marked.
Default no qinq-mark-top-only
qos
Syntax qos policy-id [shared-queuing | multipoint-shared]
no qos
Context config>service>vpls>sap>egress
config>service>vpls>sap>ingress
Description This command associates a Quality of Service (QoS) policy with an ingress or egress Service Access
Point (SAP) or IP interface.
QoS ingress and egress policies are important for the enforcement of SLA agreements. The policy ID
must be defined prior to associating the policy with a SAP or IP interface. If the policy-id does not
exist, an error will be returned.
The qos command is used to associate both ingress and egress QoS policies. The qos command only
allows ingress policies to be associated on SAP or IP interface ingress and egress policies on SAP or
IP interface egress. Attempts to associate a QoS policy of the wrong type returns an error.
Only one ingress and one egress QoS policy can be associated with a SAP or IP interface at one time.
Attempts to associate a second QoS policy of a given type will return an error.
When an ingress QoS policy is defined on IES ingress IP interface that is bound to a VPLS, the policy
becomes associated with every SAP on the VPLS and augments the QoS policy that is defined on
each SAP. Packets that are bridged will be processed using the policy defined on the VPLS SAP;
packets that are routed will be processed using the policy defined in the IES IP interface-binding
context.
When an egress QoS policy is associated with an IES IP interface that has been bound to a VPLS, the
policy becomes associated with every SAP on the VPLS and augments the egress QoS policy that is
defined on each SAP. Packets that are bridged will be processed using the policy defined on the VPLS
SAP; packets that are routed will be processed using the policy defined in the IES IP interface-
binding context.
To Next Page
Loading...
