VPLS Service Configuration Commands
Page 476 7750 SR OS Services Guide
local-address
Syntax local-address ip-address
no local-address
Context config>service>vpls>gsmp>group>neighbor
Description This command configures the source ip-address used in the connection towards the neighbor. The
local address is optional. If specified the node will accept connections only for that address in the
service running ANCP. The address may be created after the reference but connections will not be
accepted until it is created. If the local address is not used, the system accepts connections on any
interface within the routing context.
Parameters ip-address — specifies the source IP address to be used in the connection toward the neighbor.
priority-marking
Syntax priority-marking dscp dscp-name
priority-marking prec ip-prec-value
no priority-marking
Context config>service>vpls>gsmp>group>neighbor
Description This command configures the type of priority marking to be used.
Parameters dscp dscp-name — Specifies the DSCP code-point to be used.
Values be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12, cp13, af13, cp15,
cs2, cp17, af21, cp19, af22, cp21, af23, cp23, cs3, cp25, af31, cp27, af32, cp29,
af33, cp31, cs4, cp33, af41, cp35, af42, cp37, af43, cp39, cs5, cp41, cp42, cp43,
cp44, cp45, ef, cp47, nc1, cp49, cp50, cp51, cp52, cp53, cp54, cp55, nc2, cp57,
cp58, cp59, cp60, cp61, cp62, cp63
prec ip-prec-value — Specifies the precedence value to be used.
Values 0 — 7
To Next Page
Loading...
