Virtual Private LAN Services
7750 SR OS Services Guide Page 369
mst-instance
Enables the context to configure MSTI related parameters at SAP level. 486
mst-path-cost
Specifies path-cost within a given instance, expressing probability that
given port will be put into forwarding state in case loop occurs.
486
mst-port-priority
Specifies the port priority within a given instance, expressing
probability that given port will be put into a forwarding state if loop
occurs.
486
path-cost
Configures the Spanning Tree Protocol (STP) path cost for the SAP.
These are the values used for CIST when running MSTP.
490
port-num
Configures the virtual port number which uniquely identifies a SAP
within configuration bridge protocol data units (BPDUs).
490
priority
Configures the Spanning Tree Protocol (STP) priority for the SAP.
These are the values used for CIST when running MSTP.
491
root-guard
Specifies whether this port is allowed to become an STP root port. 529
no shutdown
Administratively enables an entity. 457
Configure SAP subscriber management parameters
config>service>vpls>sap>sub-sla-mgmt
def-sla-profile
Specifies a default SLA profile for this SAP. The SLA profile must be
defined prior to associating the profile with a SAP in the
config>subscriber-mgmt>sla-profile context.
530
def-sub-profile
Specifies a default subscriber profile for this SAP. The subscriber
profile must be defined prior to associating the profile with a SAP in the
config>subscriber-mgmt>sub-profile context.
530
mac-da-hashing
Specifies whether subscriber traffic egressing a LAG SAP has its egress
LAG link selected by a function of the MAC destination address instead
of the subscriber ID.
531
multi-sub-sap
Configures the maximum number of subscribers for this SAP. 531
single-sub-parameters
Enables enables the context to configure single subscriber parameters
for this SAP.
532
non-sub-traffic
Configures non-subscriber traffic profiles. 531
profiled-traffic-only
Enables profiled traffic only for this SAP. 532
sub-ident-policy
Associates a subscriber identification policy to this SAP. The subscriber
identification policy must be defined prior to associating the profile
with a SAP in the config>subscriber-mgmt>sub-ident-policy context.
533
no shutdown
Administratively enables an entity. 457
Configure mesh SDP parameters
config>service>vpls# mesh-sdp sdp-id[:vc-id] [vc-type {ether|vlan}]
accounting-policy
Configures the accounting policy that applies to the SDP. 522
Table 1: CLI Commands to Configure VPLS Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
