VPLS Service Configuration Commands
Page 522 7750 SR OS Services Guide
Service Billing Commands
authentication-policy
Syntax authentication-policy name
no authentication-policy
Context config>service>vpls>sap
Description This command defines which subscriber authentication policy must be applied when a DHCP
message is received on the interface. The authentication policies must already be defined. The
policy will only be applied when DHCP snooping is enabled on the SAP.
accounting-policy
Syntax accounting-policy acct-policy-id
no accounting-policy
Context config>service>vpls>sap
config>service>vpls>spoke-sdp
config>service>vpls>mesh-sdp
Description This command creates the accounting policy context that can be applied to a SAP or SDP.
An accounting policy must be defined before it can be associated with a SAP or SDP.
If the policy-id does not exist, an error message is generated.
A maximum of one accounting policy can be associated with a SAP or SDP at one time. Accounting
policies are configured in the config>log context.
The no form of this command removes the accounting policy association from the SAP or SDP, and
the acccounting policy reverts to the default.
Default Default accounting policy.
Parameters acct-policy-id — Enter the accounting policy-id as configured in the config>log>accounting-policy
context.
Values 1 — 99
collect-stats
Syntax [no] collect-stats
Context config>service>vpls>sap
config>service>vpls>spoke-sdp
config>service>vpls>mesh-sdp
Description This command enables accounting and statistical data collection for either the SAP or SDP, network
port, or IP interface. When applying accounting policies the data, by default, is collected in the
appropriate records and written to the designated billing file.
To Next Page
Loading...
