Configuring a VPLS Service with CLI
Page 370 7750 SR OS Services Guide
collect-stats
Enables the collection of accounting and statistical data for the SDP. 522
egress
Configures the egress label. 526
ingress
Configures the ingress label. 526
filter
Associates an IP filter policy or MAC filter policy with an egress
Service Access Point (SAP) or IP interface.
505
mfib-allowed-mda-
destinations
Enables the context to configure MFIB-allowed MDA destinations. 526
mda
Specifies an MFIB-allowed MDA destination for an SDP binding
configured in the system.
527
mac-pinning
Disables relearning MAC addresses on other SAPs 497
static-mac
Creates a remote static MAC entry in the VPLS FDB associated with
the SDP.
528
vc-label
Configures the egress or ingress VC label. 527
vlan-vc-tag
Configures the VLAN VC tag. 529
Configure spoke SDP parameters
config>service>vpls# spoke-sdp sdp-id [vc-type {ether|vlan}] [split-horizon-
group group-name]
accounting-policy
Configures the accounting policy that applies to the SDP. 522
bpdu-translation
Enables the translation of BPDUs to a given format, meaning that all
BPDUs transmitted on a given SDP will have a specified format.
460
collect-stats
Enables the collection of accounting and statistical data for the SDP. 522
disable-aging
Disables aging of MAC addresses for this SDP. 461
disable-learning
Disables learning of new MAC addresses for this SDP. 461
discard-unknown-
source
Enables the discard of packets with unknown destination MAC
addresses.
496
egress
Configures the egress label. 526
ingress
Configures the ingress label. 526
filter
Associates an IP filter policy or MAC filter policy with an egress
Service Access Point (SAP) or IP interface.
505
mfib-allowed-mda-
destinations
Enables the context to configure MFIB-allowed MDA destinations. 526
vc-label
Configures the egress VC label. 527
l2pt-termination
Enables L2PT termination on a given SAP or spoke SDP. L2TP
termination will be supported only for STP BPDUs. PDUs of other
protocols will be discarded.
460
limit-mac-move
Indicates whether or not the agent will limit the MAC re-learn (move)
rate on this SDP.
497
Table 1: CLI Commands to Configure VPLS Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
