Virtual Private LAN Services
7750 SR OS Services Guide Page 371
max-nbr-mac-addr 
Configure the max number of MAC entries in the FDB for this SDP. 498
static-mac
Creates a remote static MAC entry in the VPLS FDB associated with 
the SDP.
499
vlan-vc-tag
Configures the VLAN VC tag. 529
no shutdown
Administratively enables the SDP. 457
Configure spoke SDP STP parameters
config>service>vpls>spoke-sdp>stp
auto-edge
Enables automatic detection of edge port. 483
edge-port
Configure SAP as edge or non-edge port. 483
link-type
Configure link type of the SAP. 485
path-cost
Configures the STP path cost for the spoke SDP. 490
port-num
Configures virtual port number. 490
priority
Configures the STP priority for the spoke SDP. 491
root-guard
Specifies whether this port is allowed to become an STP root port.  529
no shutdown
Administratively enables STP for the spoke SDP. 457
Configure an egress multicast group
config>service>egress-multicast-group
description
Defines an ASCII string associated with the egress multicast group. 551
dest-chain-limit
Defines the maximum length of an egress forwarding plane efficient 
multicast replication chain for an egress-multicast-group. 
551
sap-common-
requirements
Configures the common SAP parameter requirements. The SAP 
common requirements are used to evaluate each SAP for group 
membership.
552
dot1q-etype
Specifies the dot1q EtherType that must exist on the SAP’s access port 
to allow the SAP membership within the egress-multicast-group. 
554
egress-filter
Identifies the type of filter and actual filter ID that must be provisioned 
on the SAP prior to the SAP being made a member of the egress-
multicast-group.
553
encap-type
Specifies the encapsulation type that must exist on the SAP’s access 
port to allow the SAP membership within the egress-multicast-group. 
553
Applying an egress multicast group to a VPLS SAP
config>service>vpls>sap>egress
multicast-group
Assigns a VPLS Ethernet SAP into an egress multicast group. 506
Configure a PE discovery policy
Table 1: CLI Commands to Configure VPLS Service Parameters  (Continued)
Command Description Page