Virtual Private Routed Network Services
7750 SR OS Services Guide Page 1107
The no form of the command resets all timers to their default values of 30, 180, and 120 seconds
respectively.
Default no timers
Parameters update — The RIP update timer value in seconds.
Values 1 — 600
Default 30
timeout — The RIP timeout timer value in seconds.
Values 1 — 1200
Default 180
flush — The RIP flush timer value in seconds.
Values 1 — 1200
Default 120
group
Syntax [no] group group-name
Context config>service>vprn>rip
Description This command creates a context for configuring a RIP group of neighbors.
RIP groups are a way of logically associating RIP neighbor interfaces to facilitate a common
configuration for RIP interfaces.
The no form of the command deletes the RIP neighbor interface group. Deleting the group will also
remove the RIP configuration of all the neighbor interfaces currently assigned to this group.
Default no group — No group of RIP neighbor interfaces defined
Parameters group-name — The RIP group name. Allowed values are any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
neighbor
Syntax [no] neighbor ip-int-name
Context config>service>vprn>rip>group
Description This command creates a context for configuring a RIP neighbor interface.
By default, interfaces are not activated in any interior gateway protocol such as RIP unless explicitly
configured.
The no form of the command deletes the RIP interface configuration for this interface. The shutdown
command in the config>router>rip>group group-name>neighbor ip-int-name context can be used to
disable an interface without removing the configuration for the interface.
To Next Page
Loading...
