Alcatel-Lucent 7750 SR OS - Page 1132

VPRN Service Configuration Commands
Page 1132 7750 SR OS Services Guide
Sample Output
*A:ALA-12# show service id 2 arp
==============================================================================
ARP Table
==============================================================================
IP Address MAC Address Type Age Interface Port
------------------------------------------------------------------------------
190.11.1.1 00:03:fa:00:08:22 Other 00:00:00 ies-100-190.11.1 1/1/11:0
==============================================================================
*A:ALA-12#
base
Syntax base
Context show>service>id
Description Displays basic information about the service ID including service type, description, SAPs and SDPs.
Output Show Service-ID Base — The following table describes show service-id base output fields:
Interface
The interface applied to the service.
Port
The port where the SAP is applied.
Label Description
Service Id
The service identifier.
Vpn Id
Specifies the VPN ID assigned to the service.
Service Type
The type of service: Epipe, Ipipe, Fpipe, Apipe, VPLS, IES, VPRN.
Description
Generic information about the service.
Customer Id
The customer identifier.
Last Mgmt
Change
The date and time of the most recent management-initiated change to this
customer.
Adm
The desired state of the service.
Oper
The operating state of the service.
Mtu
The largest frame size (in octets) that the service can handle.
Def. Mesh VC Id
This object is only valid in services that accept mesh SDP bindings. It is
used to validate the VC ID portion of each mesh SDP binding defined in
the service.
SAP Count
The number of SAPs defined on the service.
SDP Bind Count
The number of SDPs bound to the service.
Identifier
Specifies the service access (SAP) and destination (SDP) points.