Alcatel-Lucent 7750 SR OS - Page 1154

VPRN Service Configuration Commands
Page 1154 7750 SR OS Services Guide
Oper Path MTU
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to be
fragmented.
Far End
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Delivery
Specifies the type of delivery used by the SDP: GRE or MPLS.
Admin State
The administrative state of this SDP.
Oper State
The operational state of this SDP.
Ingress Label
The label used by the far-end device to send packets to this device in this
service by this SDP.
Egress Label
The label used by this device to send packets to the far-end device in this
service by the SDP.
Last Changed
The date and time of the most recent change to the SDP.
Signaling
Specifies the signaling protocol used to obtain the ingress and egress labels
used in frames transmitted and received on this SDP.
Admin State
The administrative state of the keepalive process.
Oper State
The operational state of the keepalive process.
Hello Time
Specifies how often the SDP echo request messages are transmitted on this
SDP.
Max Drop
Count
Specifies the maximum number of consecutive SDP echo request messages
that can be unacknowledged before the keepalive protocol reports a fault.
Hello Msg Len
Specifies the length of the SDP echo request messages transmitted on this
SDP.
Hold Down
Time
Specifies the amount of time to wait before the keepalive operating status is
eligible to enter the alive state.
I. Fwd. Pkts.
Specifies the number of forwarded ingress packets.
I. Dro. Pkts
Specifies the number of dropped ingress packets.
E. Fwd. Pkts.
Specifies the number of forwarded egress packets.
E. Fwd.
Octets
Specifies the number of forwarded egress octets.
Associated
LSP List
When the SDP type is MPLS, a list of LSPs used to reach the far-end router
displays. All the LSPs in the list must terminate at the IP address specified
in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP delivery mechanism is not MPLS
Label Description (Continued)