Alcatel-Lucent 7750 SR OS - Page 1174

VPRN Service Configuration Commands
Page 1174 7750 SR OS Services Guide
Description This command displays a summary of BGP path attributes.
Output Show Path Output — The following table describes the command output fields for a BGP path.
Sample Output
*A:ALA-12# show router 3 bgp paths
==============================================================================
BGP Router ID : 10.0.0.14 AS : 65206 Local AS : 65206
==============================================================================
==============================================================================
BGP Paths
==============================================================================
------------------------------------------------------------------------------
Path: 60203 65001 19855 3356 15412
------------------------------------------------------------------------------
Origin : IGP Next Hop : 10.0.28.1
MED : 60203 Local Preference : none
Label Description
BGP Router ID
The local BGP router ID.
AS
The configured autonomous system number.
Local AS
The configured local AS setting. If not configured, then the value is the
same as the AS.
Path
The AS path attribute.
Origin
EGP — The NLRI is learned by an EGP protocol.
IGP — The NLRI is interior to the originating AS.
INCOMPLETE — NLRI was learned another way.
Next Hop
The advertised BGP nexthop.
MED
The Multi-Exit Discriminator value.
Local Preference
The local preference value.
Refs
The number of routes using a specified set of path attributes.
ASes
The number of autonomous system numbers in the AS path attribute.
Segments
The number of segments in the AS path attribute.
Flags
EBGP-learned — Path attributes learned by an EBGP peering.
IBGP-Learned — Path attributes learned by an IBGP peering.
Aggregator
The route aggregator ID.
Community
The BGP community attribute list.
Originator ID
The originator ID path attribute value.
Cluster List
The route reflector cluster list.