Alcatel-Lucent 7750 SR OS - Page 1196

VPRN Service Configuration Commands
Page 1196 7750 SR OS Services Guide
Timeout Timer : 180 Flush Timer : 120
Counter Total Last 5 Min Last 1 Min
------------------------------------------------------------------------------
Updates Sent 0 0 0
Triggered Updates 0 0 0
Bad Packets Received 0 0 0
RIPv1 Updates Received 0 0 0
RIPv1 Updates Ignored 0 0 0
RIPv1 Bad Routes 0 0 0
RIPv1 Requests Received 0 0 0
RIPv1 Requests Ignored 0 0 0
RIPv2 Updates Received 0 0 0
RIPv2 Updates Ignored 0 0 0
RIPv2 Bad Routes 0 0 0
RIPv2 Requests Received 0 0 0
RIPv2 Requests Ignored 0 0 0
Authentication Errors 0 0 0
==============================================================================
*A:ALA-12#
route-table
Syntax route-table [ip-prefix [/mask] [longer] | [protocol protocol] | [summary]]
Context show>router
Description This command displays the active routes in the routing table.
If no command line arguments are specified, all routes are displayed, sorted by prefix.
Parameters ip-prefix[/mask] — Displays routes only matching the specified ip-prefix and optional mask.
longer — Displays routes matching the ip-prefix/mask and routes with longer masks.
protocol protocol — Displays routes learned from the specified protocol.
Values bgp, isis, local, ospf, rip, static, aggregate
summary — Displays a route table summary information.
Output Standard Show Route Table Output — The following table describes the standard output fields
for the route table.
Label Description
Dest Address
The route destination address and mask.
Next Hop
The next hop IP address for the route destination.
Type
Local — The route is a local route.
Remote — The route is a remote route.
Protocol
The protocol through which the route was learned.
Age
The route age in seconds for the route.
Metric
The route metric value for the route.