Mirror Services
7750 SR OS Services Guide Page 1321
Ingress
label
The ingress-label command is used to mirror ingressing MPLS frames with the specified
MPLS labels. The ingress label must be at the top of the label stack and can only be mirrored to a
single mirror destination. If the same label is defined with multiple mirror destinations, an error is
generated and the original mirror destination does not change.
Ingress-label allows packets
matching the ingress label to be duplicated (mirrored) and forwarded to the mirror destination. The
ingress label has to be active before it can be used as mirror source criteria. If the ingress label is
not used in the router, the mirror source will remove the ingress label automatically.
CLI Syntax: debug>mirror-source# ingress-label label [label...]
Example: *A:ALA-A>debug>mirror-source# ingress-label 103000 1048575
To Next Page
Loading...
