Common Configuration Tasks
Page 1328 7750 SR OS Services Guide
Use the following CLI syntax to create an SDP and select an encapsulation type. If you do not
specify GRE or MPLS, the default encapsulation type is GRE.
NOTE: When you specify the far-end ip address, you are creating the tunnel. In essence, you are
creating the path from Point A to Point B. When you configure a distributed Epipe SAP, you must
identify an SDP ID. Use the
show service sdp command to display the qualifying SDPs.
CLI Syntax: config>service# sdp sdp-id [gre | mpls] create
description description-string
far-end ip-addr
lsp lsp-name [lsp-name]
path-mtu octets
no shutdown
keep-alive
hello-time seconds
hold-down-time seconds
max-drop-count count
message-length octets
no
shutdown
On the mirror-source router, configure an SDP pointing toward the mirror-destination router (or
use an existing SDP):
Example:*A:ALA-A>config>service# sdp 1 gre create
config>service>sdp> description “to-GRE-10.10.10.104”
config>service>sdp> far-end “10.10.10.104”
config>service>sdp> no shutdown
On the mirror-destination router, configure an SDP pointing toward the mirror-source router (or
use an existing SDP):
Example:*A:ALA-B>config>service# sdp 4 gre create
config>service>sdp> description “to-GRE-10.10.10.103
config>service>sdp> far-end “10.10.10.103”
config>service>sdp> no shutdown
To Next Page
Loading...
