Alcatel-Lucent 7750 SR OS - Page 1360

Configuration Commands
Page 1362 7750 SR OS Services Guide
Values qtag1: 0 — 4094
qtag2 : * | 0 — 4094
The values depends on the encapsulation type configured for the interface. The following table
describes the allowed values for the port and encapsulation types..
channel-id — The SONET/SDH or TDM channel on the port of the SAP. A period separates the phys-
ical port from the channel-id. The port must be configured as an access port.
egress — Specifies that packets egressing the SAP should be mirrored. Egress packets are mirrored
to the mirror destination after egress packet modification.
ingress — Specifies that packets ingressing the SAP should be mirrored. Ingress packets are mirrored
to the mirror destination prior to ingress packet modification.
Port Type Encap-Type Allowed Values Comments
Ethernet Null 0 The SAP is identified by the port.
Ethernet Dot1q 0 — 4094 The SAP is identified by the 802.1Q tag on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
Ethernet QinQ qtag1: 0 — 4094
qtag2: 0 — 4094
The SAP is identified by two 802.1Q tags on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
SONET/SDH IPCP - The SAP is identified by the channel. No BCP is
deployed and all traffic is IP.
SONET/SDH
TDM
BCP-Null 0 The SAP is identified with a single service on the
channel. Tags are assumed to be part of the customer
packet and not a service delimiter.
SONET/SDH
TDM
BCP-Dot1q 0 — 4094 The SAP is identified by the 802.1Q tag on the channel.
SONET/SDH
TDM
Frame Relay 16 — 991 The SAP is identified by the data link connection
identifier (DLCI).
SONET/SDH
ATM
ATM vpi (NNI) 0 — 4095
vpi (UNI) 0 — 255
vci 1, 2, 5 — 65535
The SAP is identified by the PVC identifier (vpi/vci).