Alcatel-Lucent 7750 SR OS - Page 180

Configuring a VLL Service with CLI
Page 180 7750 SR OS Services Guide
Configuring Apipe SDP Bindings
Use the following CLI syntax to create a spoke SDP binding with an Apipe service:
CLI Syntax: config>service# apipe service-id [customer customer-id] [vpn
vpn-id] [vc-type {atm-vcc|atm-sdu|atm-vpc|atm-cell}] [vc-switching]
spoke-sdp sdp-id:vc-id
cell-concatenation
aal5-frame-aware
clp-change
max-cells cell-count
max-delay delay-time
egress
vc-label egress-vc-label
ingress
vc-label ingress-vc-label
no shutdown
The following example displays the command usage to create Apipe spoke SDPs:
PE router 1 (A:ALA-41):
Example: A:ALA-41>config>service# apipe 5
A:ALA-41>config>service>apipe# spoke-sdp 1:5 create
A:ALA-41>config>service>apipe>spoke-sdp# no shutdown
A:ALA-41>config>service>apipe>spoke-sdp# exit
PE router 2 (A:ALA-42):
Example: A:ALA-42>config>service# apipe 5
A:ALA-42>config>service>apipe# spoke-sdp 1:5 create
A:ALA-42>config>service>apipe>spoke-sdp# no shutdown
A:ALA-42>config>service>apipe>spoke-sdp# exit
The following output displays the Apipe spoke SDP configurations.
PE Router 1 (ALA-41):
A:ALA-41>config>service# info
-------------------------------------
...
apipe 5 customer 1 create
description "apipe test"
service-mtu 1400
sap 1/1/1:0/32 create
ingress
qos 102
exit
egress
qos 103
exit
exit