VLL Service Configuration Commands
Page 244 7750 SR OS Services Guide
port-id — Specifies the physical port ID in the slot/mda/port format.
If the card in the slot has Media Dependent Adapters (MDAs) installed, the port-id must be in the
slot_number/MDA_number/port_number format. For example 6/2/3 specifies port 3 on MDA 2
in slot 6.
The port-id must reference a valid port type. When the port-id parameter represents SONET/
SDH and TDM channels, the port ID must include the channel ID. A period “.” separates the
physical port from the channel-id. The port must be configured as an access port.
If the SONET/SDH port is configured as clear-channel then only the port is specified.
bundle-id — Specifies the multilink bundle to be associated with this IP interface. The bundle key-
word must be entered at the beginning of the parameter.
The command syntax must be configured as follows:
bundle-id: bundle-type-slot-id/mda-slot.bundle-num
bundle-id value range: 1 — 128
For example:
*A:ALA-12>config# port bundle-ppp-5/1.1
*A:ALA-12>config>port# multilink-bundle
bgprp-id — Specifies the bundle protection group ID to be associated with this IP interface. The
bpgrp keyword must be entered at the beginning of the parameter.
The command syntax must be configured as follows:
bpgrp-id: bpgrp-type-bpgrp-num
type: ima
bpgrp-num value range: 1 — 1280
For example:
*A:ALA-12>config# port bpgrp-ima-1
*A:ALA-12>config>service>vpls$ sap bpgrp-ima-1
qtag1, qtag2 — Specifies the encapsulation value used to identify the SAP on the port or sub-port. If
this parameter is not specificially defined, the default value is 0.
Values qtag1: 0 — 4094
qtag2 : * | 0 — 4094
The values depends on the encapsulation type configured for the interface. The following table
describes the allowed values for the port and encapsulation types.
Port Type Encap-Type Allowed Values Comments
Ethernet Null 0 The SAP is identified by the port.
Ethernet Dot1q 0 — 4094 The SAP is identified by the 802.1Q tag on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
Ethernet QinQ qtag1: 0 — 4094
qtag2: 0 — 4094
The SAP is identified by two 802.1Q tags on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
To Next Page
Loading...
