Alcatel-Lucent 7750 SR OS - Page 288

VLL Service Configuration Commands
Page 288 7750 SR OS Services Guide
Output Show Service SDP Using X — The following table describes show service sdp-using output
fields.
Sample Output
*A:ALA-1# show service sdp-using 300
===============================================================================
Service Destination Point (Sdp Id : 300)
===============================================================================
SvcId SdpId Type Far End Opr State I.Label E.Label
-------------------------------------------------------------------------------
1 300:1 Mesh 10.0.0.13 Up 131071 131071
2 300:2 Spok 10.0.0.13 Up 131070 131070
100 300:100 Mesh 10.0.0.13 Up 131069 131069
101 300:101 Mesh 10.0.0.13 Up 131068 131068
102 300:102 Mesh 10.0.0.13 Up 131067 131067
-------------------------------------------------------------------------------
Number of SDPs : 5
-------------------------------------------------------------------------------
===============================================================================
*A:ALA-1#
service-using
Syntax service-using [epipe] [ies] [vpls] [vprn] [mirror] [apipe] [fpipe] [ipipe] [sdp sdp-id]
[customer customer-id]
Context show>service
Description Displays the services matching certain usage properties.
If no optional parameters are specified, all services defined on the system are displayed.
Parameters [service] — Displays specified service information.
Label Description
Svc ID
The service identifier.
Sdp ID
The SDP identifier.
Type
Type of SDP: Spoke or Mesh
Far End
The far end address of the SDP
Oper State
The operational state of the service
Ingress Label
The label used by the far-end device to send packets to this device in
this service by this SDP.
Egress Label
The label used by this device to send packets to the far-end device in
this service by this SDP.