VLL Service Configuration Commands
Page 296 7750 SR OS Services Guide
Sample Output
*B:ALA-Dut-H# show service id 100 all
===============================================================================
Service Detailed Information
===============================================================================
Service Id : 100 Vpn Id : 100
Service Type : Epipe
Description : Default epipe description for service id 100
Customer Id : 100
Last Status Change: 02/06/2007 10:03:11
Last Mgmt Change : 02/06/2007 09:43:27
Admin State : Up Oper State : Up
MTU : 1514
In profile
dropped
The number of in-profile packets or octets dropped for the SAP.
Out profile for-
warded
The number of out-of-profile packets or octets (rate above CIR)
forwarded.
Out profile
dropped
The number of out-of-profile packets or octets discarded.
DHCP Relay
State
Specifies whether DHCP Relay is enabled on this SAP.
Info Option
Specifies whether Option 82 processing is enabled on this SAP.
Action
Specifies the Option 82 processing on this SAP or interface: keep,
replace or drop.
Circuit ID
Specifies whether the If Index is inserted in Circuit ID suboption of
Option 82.
Remote ID
Specifies whether the far-end MAC address is inserted in Remote ID
suboption of Option 82
Service Access Points
Managed by Ser-
vice
Specifies the service-id of the management VPLS managing this SAP.
Managed by SAP
Specifies the sap-id inside the management VPLS managing this SAP.
Prune state
Specifies the STP state inherited from the management VPLS.
Spoke SDPs
Managed by Ser-
vice
Specifies the service-id of the management VPLS managing this spoke
SDP.
Managed by Spoke
Specifies the sap-id inside the management VPLS managing this spoke
SDP.
Prune state
Specifies the STP state inherited from the management VPLS.
Label Description (Continued)
To Next Page
Loading...
