Alcatel-Lucent 7750 SR OS - Page 312

VLL Service Configuration Commands
Page 312 7750 SR OS Services Guide
Sample Output
A:SR1_3# show service id 2 sdp detail
===============================================================================
Services: Service Destination Points Details
===============================================================================
-------------------------------------------------------------------------------
Sdp Id 900:3 -(1.1.1.1)
-------------------------------------------------------------------------------
Description : Default sdp description
SDP Id : 900:3 Type : Spoke
VC Type : AAL5SDU VC Tag : 0
Admin Path MTU : 1522 Oper Path MTU : 1522
Far End : 1.1.1.1 Delivery : LDP
Admin State : Up Oper State : Up
Acct. Pol : None Collect Stats : Disabled
Ingress Label : 131069 Egress Label : 131069
Ingress Filter : n/a Egress Filter : n/a
Last Changed
The date and time of the most recent change to the SDP.
Signaling
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on this SDP.
Admin State
The administrative state of the Keepalive process.
Oper State
The operational state of the Keepalive process.
Hello Time
Specifies how often the SDP Echo Request messages are transmitted on
this SDP.
Max Drop Count
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
Hello Msg Len
Specifies the length of the SDP Echo Request messages transmitted on this
SDP.
Hold Down Time
Specifies the amount of time to wait before the keepalive operating status
is eligible to enter the alive state.
I. Fwd. Pkts.
Specifies the number of forwarded ingress packets.
I. Dro. Pkts
Specifies the number of dropped ingress packets.
E. Fwd. Pkts.
Specifies the number of forwarded egress packets.
E. Fwd. Octets
Specifies the number of forwarded egress octets.
Associated LSP
List
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS
Label Description (Continued)