Configuring a VPLS Service with CLI
Page 420 7750 SR OS Services Guide
path-cost
stp
no shutdown
Example
: config>service# sdp 101 mpls create
config>service>sdp# far-end 10.0.0.30
config>service>sdp# lsp "1toALA-B1"
config>service>sdp# no shutdown
config>service>sdp# exit
config>service# sdp 102 mpls create
config>service>sdp# far-end 10.0.0.20
config>service>sdp# lsp "2toALA-B1"
config>service>sdp# no shutdown
config>service>sdp# exit
config>service# vpls 1 customer 1 m-vpls create
config>service>vpls# mesh-sdp 300:1 create
config>service>vpls>mesh-sdp# exit
config>service>vpls# no shutdown
config>service>vpls# spoke-sdp 101:1 create
config>service>vpls>spoke-sdp# stp
config>service>vpls>spoke-sdp>stp# path-cost 1
config>service>vpls>spoke-sdp>stp# exit
config>service>vpls>spoke-sdp# exit
config>service>vpls# exit
config>service# vpls 2 customer 1 m-vpls create
config>service>vpls# mesh-sdp 300:2 create
config>service>vpls>mesh-sdp# exit
config>service>vpls# no shutdown
config>service>vpls# spoke-sdp 102:1 create
config>service>vpls>spoke-sdp# stp
config>service>vpls>spoke-sdp>stp# path-cost 1000
config>service>vpls>spoke-sdp>stp# exit
config>service>vpls>spoke-sdp# exit
config>service>vpls# exit
Note: the STP path costs in each peer 7750 SR node should be reversed (Figure 46).
To Next Page
Loading...
