VPLS Service Configuration Commands
Page 458 7750 SR OS Services Guide
SDP Keepalives — Enables SDP connectivity monitoring keepalive messages for the SDP ID.
Default state is disabled (shutdown) in which case the operational state of the SDP-ID is not affected
by the keepalive message state.
VPLS SAPs and SDPs — SAPs are created in a VPLS and SDPs are bound to a VPLS in the
administratively up default state. The created SAP will attempt to enter the operationally up state. An
SDP will attempt to go into the in-service state once bound to the VPLS.
description
Syntax description description-string
no description
Context config>service>vpls
config>service>vpls>gsmp>group
config>service>vpls>gsmp>group>neighbor
config>service>vpls>igmp-snooping>mvr
config>service>vpls>interface
config>service>vpls>split-horizon-group
config>service>vpls>sap
config>service>vpls>sap>dhcp
Description This command creates a text description stored in the configuration file for a configuration context.
The description command associates a text string with a configuration context to help identify the
content in the configuration file.
The no form of this command removes the string from the configuration.
Default No description associated with the configuration context.
Parameters string — The description character string. Allowed values are any string up to 80 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
To Next Page
Loading...
