VPLS Service Configuration Commands
Page 500 7750 SR OS Services Guide
range
Syntax [no] range vlan-range
Context config>service>vpls>sap>managed-vlan-list
Description This command configures a range of VLANs on an access port that are to be managed by an existing
management VPLS.
This command is only valid when the VPLS in which it is entered was created as a management
VPLS, and when the SAP in which it was entered was created on an Ethernet port with encapsulation
type of dot1q or qinq, or on a Sonet/SDH port with encapsulation type of bcp-dot1q.
To modify the range of VLANs, first the new range should be entered and afterwards the old range
removed. See Modifying VPLS Service Parameters on page 436.
Default None
Parameters vlan-range — Specify the VLAN start value and VLAN end value. The end-vlan must be greater than
start-vlan. The format is <start-vlan>-<end-vlan>
Values start-vlan: 0 — 4094
end-vlan: 0 — 4094
To Next Page
Loading...
