VPLS Service Configuration Commands
Page 540 7750 SR OS Services Guide
If send-queries is not enabled on this SAP or SDP, the configured query-interval value is ignored.
Default 125
Parameters seconds — The time interval, in seconds, that the router transmits general host-query messages.
Values 2 — 1024
query-response-interval
Syntax query-response-interval seconds
Context config>service>vpls>sap>snooping
config>service>vpls>spoke-sdp>snooping
config>service>vpls>mesh-sdp>snooping
Description If the send-queries command is enabled, this parameter specifies the maximum response time
advertised in IGMPv2/v3 queries.
The configured query-response-interval must be smaller than the configured query-interval.
If send-queries is not enabled on this SAP or SDP, the configured query-response-interval value is
ignored.
Default 10
Parameters seconds — Specifies the length of time to wait to receive a response to the host-query message from
the host.
Values 1 — 1023
report-src-ip
Syntax report-src-ip-address
no report-src-ip
Context config>service>vpls>igmp-snooping
Description This parameter specifies the source IP address used when generating IGMP reports. According the
IGMPv3 standard, a zero source address is allowed in sending IGMP reports. However, for
interoperability with some multicast routers, the source IP address of IGMP group reports can be
configured using this command.
Default 0.0.0.0
Parameters ip-address — The source IP source address in transmitted IGMP reports.
To Next Page
Loading...
