Virtual Private LAN Services
7750 SR OS Services Guide Page 547
Use the no form of the command to remove a static entry from the system. The specified ip-address
and mac-address must match the host’s exact IP and MAC addresses as defined when it was created.
When a static host is removed from the SAP, the corresponding anti-spoof filter entry and/or FDB
entry is also removed.
Default none
Parameters ip ip-address — Specify this optional parameter when defining a static host. The IP address must be
specified for anti-spoof ip and anti-spoof ip-mac. Only one static host may be configured on the
SAP with a given IP address.
A static host with an ip-only definition is supported and all respective limitations (such as,
enabling ip-mac and antispoof at the same time) are removed.
mac ieee-address — Specify this optional parameter when defining a static host.
Every static host definition must have at least one address defined, IP or MAC.
subscriber sub-ident-string — Specify this optional parameter to specify an existing subscriber
identification profile to be associated with the static subscriber host. The subscriber identification
profile is configured in the config>subscr-mgmt>sub-ident-policy context.
sub-profile sub-profile-name — Specify this optional parameter to specify an existing subscriber
profile name to be associated with the static subscriber host. The subscriber profile is configured
in the config>subscr-mgmt>sub-profile context.
sla-profile sla-profile-name — Specify this optional parameter to specify an existing SLA profile
name to be associated with the static subscriber host. The SLA profile is configured in the
config>subscr-mgmt>sla-profile context.
ancp-string ancp-string — Specifies the ASCII string of the DSLAM circuit ID name.
host-connectivity-verify
Syntax host-connectivity-verify source-ip ip-address [source-mac ieee-address] [interval
interval] [action {remove | alarm}]
Context config>service>vpls
config>service>vpls>sap
Description This command enables enables subscriber host connectivity verification on a given SAP within a
VPLS service. This tool will periodically scan all known hosts (from dhcp-state) and perform a UC
ARP request. The subscriber host connectivity verification will maintain state (connected vs. not-
connected) for all hosts.
Default no host-connectivity-verify
Parameters source-ip ip-address — Specifies
the source IP address to be used for generation of subscriber host
connectivity verification packets.
source-mac ieee-address — Specifies
the source MAC address to be used for generation of
subscriber host connectivity verification packets.
interval interval — The interval, in minutes, which specifies the time interval which all known
sources should be verified. The actual rate is then dependent on number of known hosts and
interval.
To Next Page
Loading...
