VPLS Service Configuration Commands
Page 600 7750 SR OS Services Guide
Sample Output
*A:ALA-12# show service id 1 labels
==============================================================================
Martini Service Labels
==============================================================================
Svc Id Sdp Id Type I.Lbl E.Lbl
------------------------------------------------------------------------------
1 10:1 Mesh 0 0
1 20:1 Mesh 0 0
1 30:1 Mesh 0 0
1 40:1 Mesh 130081 131061
1 60:1 Mesh 131019 131016
1 100:1 Mesh 0 0
------------------------------------------------------------------------------
Number of Bound SDPs : 6
------------------------------------------------------------------------------
*A:ALA-12#
mfib
Syntax mfib brief
mfib [group grp-address]
mfib statistics [group grp-address]
Context show>service>id>
Description Displays the multicast FIB on the VPLS service.
Parameters group grp-ip-address — Displays the multicast FIB for a specific multicast group address.
statistics — Displays statistics on the multicast FIB.
Output Show Output — The following table describes the command output fields:
Label Description
Svc Id
The service identifier.
Sdp Id
The SDP identifier.
Type
Indicates whether the SDP is a spoke or a mesh.
I. Lbl
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
E. Lbl
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
Label Description
Source Address
IPv4 unicast source addres
To Next Page
Loading...
