VPLS Service Configuration Commands
Page 642 7750 SR OS Services Guide
Parameters ip-int-name — Only displays the information associated with the specified IP interface name.
ip-addr — Only displays the information associated with the specified IP address.
Output IGMP Statistics Output — The following table provides statistical IGMP field descriptions
Sample Output
A:BA# show router 100 igmp statistics
Label Description
IGMP Interface
Statistics
The section listing the IGMP statistics for a particular interface.
Message Type Queries — The number of IGMP general queries transmitted or
received on this interface.
Report — The total number of IGMP V1, V2, or V3 reports trans-
mitted or received on this interface.
Leaves — The total number of IGMP leaves transmitted on this
interface.
Received Column that displays the total number of IGMP packets received on
this interface.
Transmitted Column that displays the total number of IGMP packets transmitted
from this interface.
General Inter-
face Statistics
The section listing the general IGMP statistics.
Bad Length Displays the total number of IGMP packets with bad length received
on this interface.
Bad Checksum Displays the total number of IGMP packets with bad checksum
received on this interface.
Unknown Type Displays the total number of IGMP packets with unknown type
received on this interface.
Bad Receive If Displays the total number of IGMP packets incorrectly received on this
interface.
Rx Non Local Displays the total number of IGMP packets received from a non-local
sender.
Rx Wrong Version Displays the total number of IGMP packets with wrong versions
received on this interface.
Policy Drops Displays the total number of times IGMP protocol instance matched
the host IP address or group/source addresses specified in the import
policy.
No Router Alert Displays the total number of IGMPv3 packets received on this inter-
face which did not have the router alert flag set.
To Next Page
Loading...
