VPLS Service Configuration Commands
Page 650 7750 SR OS Services Guide
vci 1, 2, 5 — 65535
dlci 16 — 1022
sdp-id — The SDP ID to be cleared.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID to be cleared.
Values 1 — 4294967295
lease-state
Syntax lease-state [no-dhcp-release]
lease-state ip-address ip-address [no-dhcp-release]
lease-state mac ieee-address no-dhcp-release
lease-state sap sap-id [no-dhcp-release]
lease-state sdp sdp-id:vc-id [no-dhcp-release]
Context clear>service>id>dhcp
Description This command clears DHCP lease state information.
Parameters no-dhcp-release — Specifies that the node will clear the state without sending the DHCP release
message.
ip-address ip-address — Clears the DHCP IP address lease state information. The ip-address portion
of the address command specifies the IP host address that will be used by the IP interface within
the subnet. This address must be unique within the subnet and specified in dotted decimal
notation. Allowed values are IP addresses in the range 1.0.0.0 – 223.255.255.255 (with support
of /30 subnets).
mac ieee-address — Clears DHCP MAC address lease state information. The 48-bit MAC address
for the static ARP in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and
ff are hexadecimal numbers. Allowed values are any non-broadcast, non-multicast MAC and
non-IEEE reserved MAC addresses.
sap sap-id — Clears DHCP SAP lease state information.
Values sap-id: null [port-id | bundle-id | bpgrp-id | lag-id | aps-id]
dot1q [port-id | bundle-id | bpgrp-id | lag-id | aps-id]:qtag1
qinq [port-id | bundle-id | bpgrp-id | lag-id]:qtag1.qtag2
atm [port-id | aps-id | bundle-id |
bpgrp-id][:vpi/vci |vpi |vpi1.vpi2]
frame [port-id | bundle-id]:dlci
cisco-hdlc slot/mda/port.channel
port-id slot/mda/port[.channel]
aps-id aps-group-id[.channel]
aps keyword
group-id 1 — 64
bundle-type-slot/mda.bundle-num
bundle keyword
To Next Page
Loading...
