IES Service Configuration Commands
Page 754 7750 SR OS Services Guide
lease-populate
Syntax lease-populate [nbr-of-entries]
no lease-populate
Context config>service>ies>if>ipv6>dhcp-relay
Description This command specifies the maximum number of DHCP6 lease states allocated by the DHCP6
DHCP relay function, allowed on this interface.
The no form of the command disables dynamic host lease state management.
Default no lease-populate
Parameters nbr-of-entries — Defines the number lease state table entries allowed for this interface. If this
parameter is omitted, only a single entry is allowed. Once the maximum number of entries has
been reached, subsequent lease state entries are not allowed and subsequent DHCP6 ACK
messages are discarded.
Values 1 — 8000
neighbor-resolution
Syntax [no] neighbor-resolution
Context config>service>ies>if>ipv6>dhcp6-relay
Description This command enables neighbor resolution with DHCPv6 relay.
The no form of the command disables neighbor resolution.
option
Syntax [no] option
Context config>service>ies>if>ipv6>dhcp6-relay
Description This command enables the context to configure DHCPv6 relay information options.
The no form of the command disables DHCPv6 relay information options.
interface-id
Syntax interface-id
interface-id ascii-tuple
interface-id ifindex
interface-id sap-id
interface-id string
no interface-id
Context config>service>ies>if>ipv6>dhcp6>option
To Next Page
Loading...
