IES Service Configuration Commands
Page 756 7750 SR OS Services Guide
source-address
Syntax source-address ipv6-address
no source-address
Context config>service>ies>if>ipv6>dhcp6
Description This command configures the source IPv6 address of the DHCPv6 relay messages.
Parameters ipv6-address — Specifies the source IPv6 address of the DHCPv6 relay messages.
Values ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
dhcp6-server
dhcp6-server
Syntax [no] dhcp6-server
Context config>service>ies>if>ipv6
Description This command enables the context to configure DHCPv6 server parameters for the IES interface.
The no form of the command disables the DHCP6 server.
max-nbr-of-leases
Syntax max-nbr-of-leases max-nbr-of-leases
no max-nbr-of-leases
Context config>service>ies>if>ipv6>dhcp6-server
Description This command configures the maximum number of lease states installed by the DHCP6 server
function allowed on this interface.
The no form of the command returns the value to the default.
Default 8000
Parameters max-nbr-of-leases — Specifies the maximum number of lease states installed by the DHCP6 server
function allowed on this interface.
Values 0 — 8000
prefix-delegation
Syntax [no] prefix-delegation
Context config>service>ies>if>ipv6>dhcp6-server
To Next Page
Loading...
