IES Service Configuration Commands
Page 766 7750 SR OS Services Guide
bpgrp keyword
type ima
bpgrp-num 1 — 1280
ccag-id ccag-id.path-id[cc-type]:cc-id
ccag keyword
id 1 — 8
path-id a, b
cc-type .sap-net, .net-sap]
cc-id 0 — 4094
lag-id lag-id
lag keyword
id 1 — 200
qtag1 0 — 4094
qtag2 *, 0 — 4094
vpi NNI 0 — 4095
UNI 0 — 255
vci 1, 2, 5 — 65535
dlci 16 — 1022
port-id — Specifies the physical port ID in the slot/mda/port format.
If the card in the slot has Media Dependent Adapters (MDAs) installed, the port-id must be in the
slot_number/MDA_number/port_number format. For example 6/2/3 specifies port 3 on MDA 2
in slot 6.
The port-id must reference a valid port type. When the port-id parameter represents SONET/
SDH and TDM channels, the port ID must include the channel ID. A period “.” separates the
physical port from the channel-id. The port must be configured as an access port.
If the SONET/SDH port is configured as clear-channel then only the port is specified.
bundle-id — Specifies the multilink bundle to be associated with this IP interface. The bundle key-
word must be entered at the beginning of the parameter.
The command syntax must be configured as follows:
bundle-id: bundle-type-slot-id/mda-slot.bundle-num
bundle-id value range: 1 — 128
For example:
*A:ALA-12>config# port bundle-ppp-5/1.1
*A:ALA-12>config>port# multilink-bundle
bgprp-id — Specifies the bundle protection group ID to be associated with this IP interface. The
bpgrp keyword must be entered at the beginning of the parameter.
The command syntax must be configured as follows:
bpgrp-id: bpgrp-type-bpgrp-num
type:
ima
bpgrp-num value range: 1 — 1280
For example:
*A:ALA-12>config# port bpgrp-ima-1
*A:ALA-12>config>service>vpls$ sap bpgrp-ima-1
To Next Page
Loading...
