IES Service Configuration Commands
Page 774 7750 SR OS Services Guide
Service Billing Commands
accounting-policy
Syntax accounting-policy acct-policy-id
no accounting-policy
Context config>service>ies>if>sap
config>service>ies>sub-if>grp-if>sap
Description This command creates the accounting policy context that can be applied to a SAP.
An accounting policy must be defined before it can be associated with a SAP.
If the policy-id does not exist, an error message is generated.
A maximum of one accounting policy can be associated with a SAP at one time. Accounting policies
are configured in the config>log context.
The no form of this command removes the accounting policy association from the SAP, and the
acccounting policy reverts to the default.
Default Default accounting policy.
Parameters acct-policy-id — Enter the accounting policy-id as configured in the config>log>accounting-policy
context.
Values 1 to 99
collect-stats
Syntax [no] collect-stats
Context config>service>ies>if>sap
config>service>ies>sub-if>grp-if>sap
Description This command enables accounting and statistical data collection for either the SAP, network port, or
IP interface. When applying accounting policies the data, by default, is collected in the appropriate
records and written to the designated billing file.
When the no collect-stats command is issued the statistics are still accumulated by the IOM cards.
However, the CPU will not obtain the results and write them to the billing file. If a subsequent
collect-stats command is issued then the counters written to the billing file include all the traffic
while the no collect-stats command was in effect.
Default collect-stats
To Next Page
Loading...
