IES Service Configuration Commands
Page 806 7750 SR OS Services Guide
------------------------------------------------------------------------------
Site : west
Description : (Not Specified)
==============================================================================
*A:ALA-12#
*A:ALA-12# show service customer 274 site west
==============================================================================
Customer 274
==============================================================================
Customer-ID : 274
Contact : Mssrs. Beaucoup
Description : ABC Company
Phone : 650 123-4567
------------------------------------------------------------------------------
Multi Service Site
------------------------------------------------------------------------------
Site : west
Description : (Not Specified)
Assignment : Card 5
I. Sched Pol: SLA1
E. Sched Pol: (Not Specified)
------------------------------------------------------------------------------
Service Association
------------------------------------------------------------------------------
No Service Association Found.
==============================================================================
*A:ALA-12#
egress-label
Syntax egress-label egress-label1 [egress-label2]
Context show>service
Description Display services using the range of egress labels.
If only the mandatory egress-label1 parameter is specified, only services using the specified label are
displayed.
If both egress-label1 and egress-label2 parameters are specified, the services using the range of labels
X where egress-label1 <= X <= egress-label2 are displayed.
Use the show router ldp bindings command to display dynamic labels.
Parameters egress-label1 — The starting egress label value for which to display services using the label range. If
only egress-label1 is specified, services only using egress-label1 are displayed.
Values 0, 2049 — 131071
egress-label2 — The ending egress label value for which to display services using the label range.
Default The egress-label1 value
Values 2049 — 131071
Output Show Service Egress Command Output — The following table describes show service
egress label output fields.
To Next Page
Loading...
