IES Service Configuration Commands
Page 820 7750 SR OS Services Guide
Ingress Filter
The ID of the ingress filter policy.
Egress Filter
The ID of the egress filter policy.
Far End
Specifies the IP address of the remote end of the GRE or MPLS
tunnel defined by this SDP.
Last Changed
The date and time of the most recent change to this customer.
Signaling
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on this SDP.
Admin State
Specifies the operating status of the keepalive protocol.
Oper State
The current status of the keepalive protocol.
Hello Time
Specifies how often the SDP Echo Request messages are transmitted
on this SDP.
Hello Msg Len
Specifies the length of the SDP Echo Request messages transmitted
on this SDP.
Max Drop Count
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
Hold Down Time
Specifies the amount of time to wait before the keepalive operating
status is eligible to enter the alive state.
SDP Delivery Mech-
anism
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP
address specified in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS
Number of SDPs
The total number SDPs applied to this service ID.
Service Access Points
Service Id
The service identifier.
Port Id
The ID of the access port where this SAP is defined.
Description
Generic information about the SAP.
Encap Value
The value of the label used to identify this SAP on the access port.
Admin State
The desired state of the SAP.
Oper State
The operating state of the SAP.
Last Changed
The date and time of the last change.
Admin MTU
The desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring
the packet to be fragmented.
Label Description (Continued)