Virtual Private Routed Network Services
7750 SR OS Services Guide Page 963
Description This command adds a static (*,G) entry. This command can only be enabled if no existing source
addresses for this group are specified.
Use the no form of the command to remove the starg entry from the configuration.
Default none
subnet-check
Syntax [no] subnet-check
Context config>service>vprn>igmp>interface
Description This command enables subnet checking for IGMP messages received on this interface. All IGMP
packets with a source address that is not in the local subnet are dropped.
Default enabled
version
Syntax version version
no version
Context config>service>vprn>igmp>interface
Description This command specifies the IGMP version. If routers run different versions of IGMP, they will
negotiate the lowest common version of IGMP that is supported by hosts on their subnet and operate
in that version. For IGMP to function correctly, all routers on a LAN should be configured to run the
same version of IGMP on that LAN.
For IGMPv3, note that a multicast router that is also a group member performs both parts of IGMPv3,
receiving and responding to its own IGMP message transmissions as well as those of its neighbors.
Default 3
Parameters version — Specifies the IGMP version number.
Values 1, 2, 3
query-interval
Syntax query-interval seconds
no query-interval
Context config>service>vprn>igmp
Description This command specifies the frequency that the querier router transmits general host-query messages.
The host-query messages solicit group membership information and are sent to the all-systems
multicast group address, 224.0.0.1.
Default 125
To Next Page
Loading...
