VPRN Service Configuration Commands
Page 992 7750 SR OS Services Guide
Parameters text — The string can be any combination of ASCII characters up to 32 characters in length. If spaces
are used in the string, enclose the entire string in quotation marks (“ ”).
system-id
Syntax [no] system-id
Context config>service>vprn>if>dhcp>option>vendor
config>service>vprn>sub-if>grp-if>dhcp>option>vendor
Description This command specifies whether the system-id is encoded in the Alcatel-Lucent vendor specific sub-
option of Option 82.
Default None
proxy-server
Syntax proxy-server
Context config>service>if>dhcp
config>service>vprn>sub-if>grp-if>dhcp
Description This command configures the DHCP proxy server.
emulated-server
Syntax emulated-server ip-address
no emulated-server
Context config>service>vprn>if>dhcp>proxy
config>service>vprn>sub-if>grp-if>dhcp>proxy-server
Description This command configures the IP address to be used as the DHCP server address in the context of this
service. Typically, the configured address should be in the context of the subnet.
The no form of this command reverts to the default setting. The local proxy server will not become
operational without a specified emulated server address.
Parameters ip-address — Specifies the emulated server address.
Default Note that for a retail interface, the default is the local interface.
lease-time
Syntax lease-time [days days] [hrs hours] [min minutes] [sec seconds] [radius-override]
no lease-time
Context config>service>vprn>if>dhcp>proxy
config>service>vprn>sub-if>grp-if>dhcp>proxy-server
To Next Page
Loading...
