IES Interface Commands
Page 1000 7750 SR OS Services Guide
If the customer-site-name does not exist, it is assumed that an attempt is being made to create a
site of that name in the customer ID context. The success of the command execution depends on
the following:
• The maximum number of customer sites defined for the chassis has not been met.
•The customer-site-name is valid.
•The create keyword is included in the command line syntax (if the system requires it).
When the maximum number of customer sites has been exceeded a configuration error occurs;
the command will not execute and the CLI context will not change.
If the customer-site-name is invalid, a syntax error occurs; the command will not execute and the
CLI context will not change.
Values Valid names consist of any string up to 32 characters long composed of printable, 7-
bit ASCII characters. If the string contains special characters (#, $, spaces, etc.), the
entire string must be enclosed within double quotes.
static-host
Syntax static-host ip ip/did-address [mac ieee-address] [create]
static-host mac ieee-address [create]
no static-host [ip ip-address>] mac ieee-address>
no static-host all [force]
no static-host ip ip-address
Context config>service>ies>if>sap
config>service>ies>subscriber-inf>group-inf>sap
Description This command configures a static host on this SAP.
Parameters ip ip-address — Specifies the IPv4 unicast address.
mac ieee-address — Specify this optional parameter when defining a static host. Every static host
definition must have at least one address defined, IP or MAC.
force — Specifies the forced removal of the static host addresses.
sla-profile sla-profile-name — This optional parameter is used to specify an existing SLA profile
name to be associated with the static subscriber host. The SLA profile is configured in the
config>subscr-mgmt>sla-profile context.
ancp-string
Syntax ancp-string ancp-string
no ancp-string
Context config>service>ies>if>sap>static-host
config>service>ies>subscriber-inf>group-inf>sap>static-host
Description This command specifies the ANCP string associated to this SAP host.
To Next Page
Loading...
