VPRN Service Configuration Commands
Page 1192 7750 SR OS Services Guide
Only one DSCP name/value can be configured per application, if multiple entries are configured then
the subsequent entry overrides the previous configured entry.
The no form of this command reverts back to the default value.
Parameters dscp-app-name — Specifies the DSCP application name.
Values ldp, rsvp, bgp, rip, msdp, pim, ospf, igmp, mld, telnet, tftp, ftp, ssh, snmp, snmp-
notification, syslog, icmp, traceroute, tacplus, dns, ntp, radius, cflowd, dhcp, bootp,
ndis, vrrp, srrp
dscp-value — Specifies a value when this packet egresses the respective egress policy should provide
the mapping for the DSCP value to either LSP-EXP bits or IEEE 802.1p (Dot1P) bits as
appropriate otherwise the default mapping applies.
Values 0 — 63
dscp-name — Specifies the DSCP name.
Values none, be, ef, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cp9, cs1, cs2, cs3, cs4, cs5, nc1, nc2,
af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, cp11, cp13,
cp15, cp17, cp19, cp21, cp23, cp25, cp27, cp29, cp31, cp33, cp35, cp37, cp39,
cp41, cp42, cp43, cp44, cp45, cp47, cp49, cp50, cp51, cp52, cp53, cp54, cp55,
cp57, cp58, cp59, cp60, cp61, cp62, cp63
dot1p-priority — Specifies the Dot1P priority.
Values 0 — 7
dot1p-app-name — Specifies the Dot1P application name.
Values arp, isis
dscp
Syntax dscp dscp-name fc fc-name
no dscp dscp-name
Context config>service>vprn>sgt-qos
Description This command creates a mapping between the DiffServ Code Point (DSCP) of the self generated
traffic and the forwarding class.
Self generated traffic that matches the specified DSCP will be assigned to the corresponding
forwarding class. Multiple commands can be entered to define the association of some or all sixty-
four DiffServ code points to the forwarding class. For undefined code points, packets are assigned to
the forwarding class specified under the default-action command.
All DSCP names that defines a DSCP value must be explicitly defined.
The no form of this command removes the DiffServ code point to forwarding class association. The
default-action then applies to that code point value.
Default none
Parameters dscp-name — The name of the DiffServ code point to be associated with the forwarding class.
DiffServ code point can only be specified by its name and only an existing DiffServ code point
can be specified. The software provides names for the well known code points.
To Next Page
Loading...
